We've received feedback that users have made successful integration of iblinds within a Lutron system using Hubitat & using Pico remotes or Alexa for operation.

Just wanted to let you know that I temporarily connected one of my iBlinds to my Oomi system.  It connected easily and showed up as a dimmer.  Tap the widget to open and close the blinds and by holding the widget you can choose the percent of opening.

@wounded

Thanks so much for the feedback. I added Oomi to our list. 

Yesterday included my iBlinds to Fibaro Home Center controller. It is recognized as Blinds controller.

Seems to work with the universal devices isy - added as a binary and multilevel device - works in its programs and with alexa's open/close routines when exposed to the isy portal

I've also got mine working with my isy994i with added z-wave support.

It's added as a binary and multilevel device as @sloop mentioned. I've set up scenes using the multilevel device and defined the 50% as the level when the scene is on. Those scenes are exposed to Alexa and I can trigger them to open the blinds with "Open Den Blinds" (or whatever ones I want). "Close Den Blinds" will return them to the 0% setting. I haven't found a way to have them close in the "up" - but the isy does allow setting configuration parameters on devices.

I've only exposed my scenes to Alexa, not the individual devices.

@chasepeeler Can I ask how you added it to ISY when i add it (ISY 5.3.0) i only get a binary switch and a class b motor ctrl, I can't see anyway to set to anything other than 0 or 100%.

Thanks,

Steve

i added mine under isy 5.2.0 - shows up the same as yours - but not having any luck with them - the v2 iblinds still work and never have a problem - the v3 iblinds are not working - open and close sometimes but not to the correct level - isy gives an error message

my config - added the zwave isy board with the zwave 500 chip and 3 repeaters (the ones iblinds recommends) awhile back (before i knew about iblinds) - thought i was boing to try zwave motion detectors - one repeater is in the wiring closet with the isy - one at each end of the house in the attic - added 4 iblinds v2 (2 at one end of the house and 2 at the other end) and they never had a problem - they were added as a multilevel switch and binary device - got 3 of the v3 iblinds and they added as a motor ctrl and binary device - nothing but trouble

i am not a zwave guy - every light is insteon - elk and portal - so i am unsure about how zwave works - if these battery devices sleep and if the communications path uses one that is sleeping, might be a problem - i see a zwave 'wake' command and read somewhere iblinds does not support that - assumed that 700 zwave devices would be backwards compatible with 500 zwave - that might be wrong

i'll keep trying but not much on the isy forum with these devices and could not get logged on here to reply to you - at this point i'd say the v3 does not work with the isy

also - read the isy does not support security level v2 - also assumed it the iblinds device would negotiate backwards